Setting up razberry z wave on HASSIO

[jebo (Jesper Borglund)]

Hi,
This might be a very basic question but im not able to find the answer in the forum or elswhere. Im trying to set up zwave with razbeery board on a rpi3. looking at instructions on this page https://home-assistant.io/hassio/zwave/ i understand that i need to add a line to the config.txt file. But now to the question: how do i do this? Do I need to ssh to the pi and then?
any pointers in the right direction would be helpful.

[bboti86 (Botond Barabas)]

Hi!
The easiest way is to put your sd card into a PC and edit the file there.
Check out this post:

Need help getting ZWave GPIO on raspberry-pi3 to work

Hey! I’ve struggled with this yesterday and now I was able to work out what’s wrong. I have the Razberry add-on board from ZWave.me on the Raspberry pi 3. The process is: remove the SD Card from the pi and connect it to your PC (in windows a drive will show up, in linux you have to mount one of the partitions) open config.txt and paste dtoverlay=pi3-miniuart-bt to the end of it, save the file and put the card back to the pi after the pi boots up open Home Assistant and install the SSH Serve…

B

[jebo (Jesper Borglund)]

Thanks! I’ll try that and thanks for the link.