Setup Aeotech Z-Stick with Docker

Configuration Z-Wave
1

Hello,
I have problem or doubt, about an installation with the Aeotech Stick and Docker. The Aeotech Stick is part of my Zwave network, it is added to my primary contractor, but in HA when there is a “Start Network”, only a few devices appear, I don’t see the complete list.

I am very new to this, so I am not sure if they should all appear … does any advice help?

Thks!

2

I seen to recall reading somewhere that when including devices with Aeotech you should do it through HA and not by using the button on the stick. I think if you did the latter, that is the reason you’re only seeing a few devices.