Sonoff T1 Tasmota - Configure Module Settings > Buttons not working?

Hardware
1

Hello,

I have just flashed Tasmota on T1 1 Channel and 3 Channel light switches.

The physical buttons when pressed show in Console as Toggle but don’t actually do anything as far as turning on the lights.

On my sonoff Basics I assigned GPIO14 as 09 Switch to make the button work, but when I assign 09 on T1s it doesn’t have the same outcome.

I did some googleing but couldn’t find any setups of T1 in tasmota.

sonoff%20t1%201channel
sonoff%20t1%201channel507×582 40.3 KB

Screenshot_1
Screenshot_11489×676 177 KB

2

False alarm. They are working without any settings needed in the Module config. The 1Channel is working perfectly after power reset the 3Channel T1 is very bad at responding to my touch but it does work if I keep tapping it. The 3 channel one was my first one I did and I think I touched the buttons under the cover too much with my dirty fingers whilst I was soldering wires on during flashing.