Spook not clearing Firmware update required after update

Configuration Zigbee
1

Spook recently indicated that a couple of Zigbee sensors were ready to be update via OTA. I have successfully upgraded one of these but spook is still showing it on the previous version with an update. The OTA tab in zigbee2mqtty show the device has upgraded and that there are no pending updates. I cannot clear the spook message or even skip it. Note that I have restarted Homeassistant.

Any assistance with this would be greatfull received.

2

Restarting Home Assistant or clearing a browser cache may clear the issue. If it doesn, it sounds like an issue with Spook and that is where to type in the “issue” issue, the Spook GitHub.

3

Thanks, It is sorted, Clearing the browser cache did the trick.