Synology Security Status

[Judocrafter (Domenik)]

Hello

How can I find out the error of the security status warning?

Network and SystemCheck have the status “warning”

I used the following sensor

• entity: binary_sensor.domenik_security_status
  type: entity

[Burningstone]

You need to check in your Synology DSM. This has nothing to do with Home Assustant. It would be better to ask this question in a Synology forum.

[uiguy]

Go to the security advisor application in your synology dsm. there it will tell you what the issues are…

[squirtbrnr]

By searching the forums. This has been discussed:

0.111: Frontend loaded sooner, Elexa Guardian, Unify Circuit, Acmeda

wait… this is truly important… you say the security is an attribute set on/by the Synology system itself? And only read from and displayed in HA through the new binary_sensor? If that is a fact, it should be available in my Synology DSM itself too, wouldn’t it? And since I hadn’t been there for quite a while I just gave it a quick go… there’s a new security advisor in the DSM, advising to be enabled (which is it wasn’t). [Schermafbeelding 2020-06-11 om 14.05.41] So, I hit the enable button,…

And read the few posts following and the other linked thread.

[Judocrafter (Domenik)]

Thank you! you are great!