I have just added a Conbee to my Raspberry Pi so that I can start automated zigbee devices in HA.
I have installed the deConz add-on and successfully added two Ikea bulbs and the Tradfri remote control through the Phoscon app in HA.
I can control the bulb with the Phoscon app (dimming up/down, changing color temperature and swithing on/off).
I have issues with the Tradfri remote control. I have managed to pair it successfully and I have configured the buttons this way
First of all the dimming and color control don’t work the same way it worked before when my remote was directly connected to the bulb (without conbee). Before a single press on any of these buttons would trigger an incremental change. Now I have to long press and wait for too long before seeing a change (probably the increments are too small)
And sometimes I don’t see any changes at all, I have to press again.
How can I change the increments and is it “normal” to have inconsistent results, is it a compatibility issue ? I thougth about radio frequency issues, but the all the devices, including the raspberry, are in the same small room.