WLED lights for your Bambu Labs 3d printer

[carltonwb]

Since your blueprint seems the most current and updated, I have a question.
I am at a loss as to what to fill in on the blueprint.
Lets say I want it to turn on the light when it starts printing.
I have these choices

Print Status of your Bambu Lab printer
Current Stage of your Bambu Lab Printer
Printer state On/Off of your Bambu Lab Printer
WLED Light devices

So based on the four choices would this be correct

Print Status of your Bambu Lab printer <sensor.p1p_black_print_status>
Current Stage of your Bambu Lab Printer <sensor.p1p_black_current_stage...>
Printer state On/Off of your Bambu Lab Printer
WLED Light devices <light.wled_p1p_black>

I am unsure what to enter on Current stage Printer state On/Off.

Any samples would be most appreciated
Thank you

[Paul_Biod]

Hi,

Print Status of your Bambu Lab printer :
sensor.p1s_01p00a3b2500947_etat_de_l_impression (in english, it 'd be print state). Values use to be : printing/offline/online/etc…

Current Stage of your Bambu Lab Printer:
sensor.p1s_01p00a3b2500947_etape_actuelle ( in english, it’d be printing stage)

Printer state On/Off of your Bambu Lab Printer:
P1S_01P00A3B2500947 État (in english : state)

WLED Light devices:

[carltonwb]

Merci Beaucoup,
Figured out three of the four, but one question left is in regards to the binary sensors.
These are the binary sensors I have for this printer

binary_sensor.p1p_black_firmware_update
binary_sensor.p1p_black_hms_errors
binary_sensor.p1p_black_online
binary_sensor.p1p_black_recording_timelapse

I do not have one that has is a state entity. Am I missing something in regards to this. If so how or where do I activate that sensor.

[dreed47 (David Reed)]

you need both the bambu HACs integration and the wled integration installed…do you have both?

[carltonwb]

Yes both are installed.

[Paul_Biod]

Hi !
The binary sensor you are looking for is in the diagnostic section :

hope it helps

[carltonwb]

Still confused.
I understand your French names, but mine do not match.
Opening everyone to show the entity name none of them say state.
Here is what is displayed.

[DarkNostris]

Does someone has a blueprint for normal LED strip controller? I already have one of the Chinese RGB controllers. Don’t want to setup ESP specially for this.

Edit: I reverse-engineered the blueprint and got it working but common blueprint would be nice

[jbhobson (Justin H.)]

@JHoke John,

Just wondering which Athom WLED and RGBW LED strip device your using and if you got this going ?
Thinking it would be simpler to use an athom, than solder up ESP32 / print case etc.

Thanks.