Wondering how to get use off sensor_X_alarm_level

Configuration Z-Wave
1

So I have these enteties, but I cannot figure out to find them usefull. My Z-wave device is only a lock state locked/unlocked. These sensor states are always 0 regardless if the lock is locked or unlocked. any tips? I have installed the danapad wich is a wireless keypad for the danalock. it is kind of a slave since it is controlled by the z-wave lock via bluetooth. I am wondering if I maybe could use this sensors to notify me if wrong pin is tried.

I have the same kind of enteties for my magnet switch.

sensor.polycontrol_danalock_v3_btze_alarm_level 
sensor.polycontrol_danalock_v3_btze_alarm_type

Thank you.

2

With the Danapad, can you trigger automations when pin is correct?

Do you feel it is reliable? Is it worth the money? :slightly_smiling_face:

3

Sorry, I found out you can not… Alarm level only change if you open lock manually, remotely(HA or app) or with the danapad. I was hoping I could get an notification if someone tried to hack the pin…

The danapad itself, and the danalock works great if you use it with HA. It is the app thats bad so you get problems if you need to configure it with the app…