I’m very new to HA, and just setting things up. I plugged in my AEOTEC Z-stick gen 5 and it immediately set off all the smoke detectors in the house. Is this normal when first installing a Z-stick? Is there some way to get around this behavior so I can configure it in HA without annoying the entire family?
Thanks,
Ken
Are your smoke detectors Zwave? If so, were they paired before you plugged the stick in? It could have sent a basic command, but… that doesn’t make sense.
Hate to ask, but did you try just once? Have you tried it again?
Well, I’ll be… I waited until everyone was up, warned them, and plugged it back in, without an issue. Guess it was just the first time thing.