I added 16 ZEN76 switches to my Z-Wave network yesterday through SmartStart.
Since then, the Z-Wave JS UI control panel reports at the top “Secure inclusion started”.
If I go to “Manage nodes”, there is a button to stop inclusion, which I hit, but it doesn’t actually work.
How can I make it really stop ?
Shutdown, unplug the stick for a minute, replug the stick, start up
Thanks. That did it.
Please mark my answer as the solution.
I did. However, I keep running into this again. I haven’t done anything that would cause Z-Wave JS UI to go into inclusion. It just seems to go into this mode all on its own, very strangely. I’d like to address the root cause rather than just the symptom. What could be causing it ?
A place to start is to enable debug logging for zwavejs and look in the log files to see when / what time inclusion starts.