Zigbee group does not work

  1. To control the result, I use MQTT-Explorer
  2. ADD Group, result:
    zigbee2mqtt
    bridge
    groups = [{“friendly_name”:“light_lestnica_1_2_etag”,“id”:1,“members”:[{“endpoint”:1,“ieee_address”:“0xa4c138c7e37fbab8”},{“endpoint”:1,“ieee_address”:“0xa4c1382989d7f3b8”}],“scenes”:[]}]
    response
    group
    members
    add = {“data”:{“device”:“0xa4c1382989d7f3b8/left”,“group”:“light_lestnica_1_2_etag”},“status”:“ok”,“transaction”:“ujd9i-2”}
  3. a group appears in the Home system, which is normally displayed and normally managed in the web interface.
  4. but when the status changes in the group, the device does not respond to this, and goes into a strange state.
    Switch-1-1 = {“backlight_mode”:“medium”,“color_mode”:“xy”,“linkquality”:61,“power_on_behavior”:null,“power_on_behavior_left”:“off”,“state_center”:“OFF”,“state_left”:“ON”,“state_right”:“OFF”}
    left
    set = OFF

the problem is observed on devices TuYa TS0012 control via MQTT | Zigbee2MQTT (and similar)

with the switch Xiaomi QBKG41LM it works fine.

That is, the problem is with a specific model TyYa