Hello,
I would like to build a load-cell bed occupancy sensor like in this guide but on my bed, each horizontal pair of legs (it has 4) is connected by a wooden bar so I don’t have 4 separate legs but two of these bars.
Could I also just align the load cells like in the guide but on each corner of each bar?
Also, I plan to use this load cell amplifier and 4 of these load cells
Sorry for the German links…
I already have an M5Stack Atom lite ESP32 module, so I went with the M5 module because I am not that good at soldering.
My Questions are:
- Does the positioning, how I planned it, work for such a bed?
- How can I mount the cells without a 3D printer?
- Do these load cells and the amplifier I linked work with ESPHome?
Best regards
Aaron