How to add 433 MHz outlets? (Tellstick)

[bonterra]

I finally managed to get both Z-wave and Tellstick working in HA.

I’ve got a couple of cheap 433 MHz self-learning outlets that I would like to use for non-critical applications but I can’t figure out how to add them to HA. My 433 MHz temperature sensors show up nicely in the GUI after I added them to the configuration file but I can’t figure out how to add my switches. Do I have to use Tellcenter to find the codes for each one or is there an easier way?

[gpbenton (Graham)]

How to make use of generic 433Mhz sensors?

@masterkenobi Hello, I think I finally found a solution to my problem. I await your confirmation if this will or will not work. The idea is to replace my common home switches, for some RF, ie I want to both turn the lights on / off by pressing the switch. As well as on / off by the home assistant. My doubts are as follows: When you press the switch, it issues a command Rf to on and issues an Rf command to off? If so, I think this will solve my problem and so I can replace all my normal …

433toMQTTto433 Gateway Device List

1technophile created an arduino or Esp8266 gateway that can receive and transmit to 433 Mhz devices using MQTT with Home Assistant. I want to create a forum topic that will highlight all the devices that this can control. (EDIT: RCSwitch users and even MySensors 433 devices too!!) Here is a google doc spreadsheet of all the devices we found compatible. Thanks @touliloup Oh and we are now moved to the new “Hardware Forum”!!) I have 15 Etekcity switches, 3 driveway motion sensors, and a wi…

[frelev]

I usually used tellcenter to generate the codes and then copied them to tellstick.conf
But you should be able to generate the code from HASS as described here:

RFXtrx Switch

[bonterra]

@frelev: Thanks, I realize I have been looking at this from the wrong end so to speak, instead of trying to find out what codes are currently used by my outlets I just need to generate new ones and have the outlets learn them.

[bonterra]

So, two of my outlets work fine. The third one listened to two codes, the correct one and one of the others. I tried teaching it a new code but it wouldn’t listen. Now it doesn’t respond to any commands…