Ikea E1524/E1810 zigbee round 5 button update problem

[pepe2 (Pepe)]

Hi, I have a Ikea E1524/E1810 zigbee round 5 button and in the Setting I have a update for that button. The update is now already more the 3 hours turning and still going.
Is there a way to stop or interrupt the update? I don’t find a stop button.

How can I update the IKEA button? What do I have to do so that the update is working?
Thanks.
Peter

[FloatingBoater (James Derrick)]

Your expectations are a bit high for a low-bandwidth RF link. Zigbee is s-l-o-w compared with WLAN, so a firmware update is something you enable and wait a few DAYS before checking back. My devices use ZHA and run Firmware: 0x24040005.

The monster IKEA TRÅDFRI thread has lots of information (perhaps too much?):

IKEA Tradfri - Batteries in the remote controls are quickly discharged

For several weeks I have had a problem with batteries that power IKEA Tradfri remote controls. New batteries discharge only after a few days and the remote controls stop working. All devices work in a small apartment, I did not change their position and previously I did not have such problems (I have been using this equipment for almost 2 years). Could this be caused by incorrect configuration in HA? I will be grateful for your help.

If this helps, this post!

[pepe2 (Pepe)]

My zigbee update is still running already for 4 day’s, how can I stop this? Or do I have to wait still some day’s?

Thanks

[FloatingBoater (James Derrick)]

Hint: click the links in my post above.

[pepe2 (Pepe)]

@FloatingBoater

firmware update is something you enable

If I click on that link, it is all about ZHA and I use zigbee2mqtt ? I think I can’t use that link.

The second link is about : IKEA Tradfri - Batteries in the remote controls are quickly discharged => This is not about to stop the installation on a zigbee device.

Or do I miss something? Because I’m new all of this !