I’d love to use the new termostat card with the lovelace UI and my thermostat but I can’t figure out how to set that upper and lower ranges. All the examples I see reference the nest or ecobee which show up as a single climate entry but my zwave thermostat shows up as two climate entries (one cooling and one heating).
Is there a way to either combine the heating and cooling down to a single climate entry (found this question that’s not been answered) or to specify multiple climate entries in the lovelace ui component.
My thermostats are all zwave also. And they just would not work at all with built in zwave in HA when i installed them. So they are running via mqtt through my old smartthings. Would love to get some of the new lovelace stuff too.