I’m planning to change my old router/modem/AP (ConnectBox from UPC). I hope you could help me choose one. My requirements are:
I have Xiaomi IoT devices and LG TV so client segmentation would be nice (vLANs?),
I’m planning to run VPN to access my HA instance (hass.io, DuckDNS + Let’s Encrypt) remotely (as a addon on my hass.io or as a separate package on RPi 3B+ / Raspbian). I will try to configure it in the way that accessing xxx.duckdns.org will require to be on the VPN (is it event possible?)
for other network traffic (from other devices like laptops and phones) I would like to route traffic via my NordVPN access (OpenVPN) - it also could be set up as hass.io VPN tunell in NordVPN connection.
I wanted to get the USG + Unifi Cloud Key + any compatible Ubiquiti AP
I have 500Mbps for now and the clients in which I want to take advantage of the speed are wired.
I want my WiFi/IoT devices to be able to reach 200-250Mbps on 2.4Ghz. I have a small place, about 1500Sq condo. What are the recommendations for AP?
USG and Unifi Cloud Key is a go, but I am having a hard time finding the right AP. Should I go for the UAP AC LR, UAP AC Lite or the UAP-AC-IW? I am planning to put it on a wall, not ceiling mounted.
Not if you only have a router. If you have the USG or multiple AP, switches, etc then you should get it… However you can also use any VM, Raspberry Pi or whatever you have around to run the software.
Personally I am running the controller in another docker. its overkill for one AP though but I do it for presence detection since before direct AP component was released. Also allows me to easily expand the network as/if needed.
you could also go for the ER-X cost only a 1/3 and does the same job - Or do you want to run HA of this router? got one UAP AC Lite on the ER-X and my Modem under Singleuser mode (UPC calls it modem mode)
For your VPN you could install zero-tier. Deam easy to set up and with 3 routing roules and one setting in your account you can connect to your Home network.
How do you measure speed?
Reported link from the device/AP?
Actual measured throughput?
Or just gut feel? - in this case the number of complaints in the home is low.
Max throughput to single device, I know they’ll prob share bandwidth with all other devices but these barely use any in my case. I’ve got all the network for myself.
Going back to my question. Will the UniFi AC Lite be sufficient for small flat? Can I use the RPi as a VPN server (to connect to my HA instance from the outside) and for the other outgoing connections (different vLAN) connect to different VPN service using OpenVPN?
OK thanks. I dug in a bit more and figured it out.
From what I found out it looks like the minimum requirement to have a working setup that will provide internet access, routing and wifi will need three different devices: a USG, edge router and a wifi AP.
is that basically correct?
and I don’t think i would need a cloud key, or would I?