I used Balena Etcher to copy a Raspberry Pi 3B image to an SD card. After I boot the Pi, the HA CLI comes up. When I try to go to the web interface I get a page not found error. When I run the HA network info command, I don’t see an IP address for WiFi. At no point in the process was I asked to pick…

Hold back, @pmaine is trying to install over wifi (or else why would he be expecting a SSID) - the instructions are quite clear - Raspberry Pi - Home Assistant To quote: Insert the boot media (SD card) you just created. Attach an Ethernet cable for network.

No IP Addresses or Web Interface to HA

Installation

lordwizzard (Lordwizzard) February 24, 2023, 3:16am 3

Here are some CLI helps:

Some more: