Philips Dynalite lighting + switches

Third party integrations
67

Is this only possible with a bridge in between the dynalite gateway and router?

68

Yes you need a bridge, If you have already the PDEG then use it. Otherwise you need to buy the one @uzelac referred to or similar

69

Okay I already have the envision gateway setup and have previously used the app but am wanting to intergrate google home?

70

For google assistant integration check this link

71

There is a switch, boolean if i rememver correctly in config which you need to toggle to true and it will work.
It’s a bit laggy but it works.

72

active and pooltimer

73

BTW.
If you have IP -> RS485 gateway, that is all the hardware you need to connect with Dynalite software…

74

Thank you, I have checked it and as you said it is laggy. about Dynalite software I always get bad packet in the log. Sometimes it gives the correct packet. If you have tried a gateway that works please let me know or maybe my configuration is not correct, I have posted my configuration up if you would like to take a look.

Thank you

75

I dont have any issues with EP, it is easier with PDEG but still works with 10x cheaper IP-485 gateway.

76

Is it still laggy? I’m in the process of building and need to choose between Dynalite and C-bus. I’m hoping that Dynalite will be nice and fast with HA

77

Yes, it is still laggy, I purchased another bridge and I will check if the issue is for that. It wont update the states as expected when the button is pushed physically.

78

Hey All,

I’m finding that several times I’ve got to tell hass the same command twice for it to respond, then once it’s “awake” it’s fine do you know if any poll or keep alive parameters to stop this as in hass loveface cards or on google home using nabu casa it just doesn’t respond first go, second go and for a couple of hours fine then goes sleeping again

Ta

Nick

79

What are you using for your IP-485 gateway?

80

I have both chinese i recommended and genuine Philips.
No difference, both work the same.

81

Can you please share the configuration on the Chinese 485 bridge

Thanks

82

I’ve just setup the PDEG and it works for turning lights on/off from HA with no latency. The issue I’ve got is that when you change a light status from a physical switch, it doesn’t update the status in HA.

Does this happen for you or do you get 2-way sync?

83
84

Untitled
Untitled1050×886 41.1 KB

I must say i forgot how I set it up :).
Hope it works.

85

Thank you, Do you have check sum error? I’v been getting a lot recently

86

Check sum ? Not sure I know what you mean.
Where can i check that ?