If you are running Hass.io then I guess you can’t, if you are running Hassbian or similar then run the script file mentioned in the github - scs-monitor.
Hi keithh666,
thanks for the answer.
I have still not clear the point but in the mean time could you send me your configuration file about scsgate ?
Just for your information I have installed Hass.io on my PC I don’t have Raspberry Pi 3 (for the moment).
For me is not clear how to specify the IP where I found escape_gate and how to configure the port used for UDP protocol.
If I have understood well scs-monitor is only to recognize the BTICINO address but If I have an example mybe I can generate for all the light witheout the monitor
Regards, Gianluigi.
I don’t have one I was just reading from the github that you posted Since you are running Hass.io I suspect you won’t be able to run the necessary files to generate the config, but I could be wrong Since there is no component for scsgate and you would need to install scsgate with sudo pip install scsgate, which you can’t do in Hass.io I believe as you don’t have any access to the underlying OS, you would have to write an addon to get it working, I think. Hopefully someone will come along and prove me wrong!
EDIT: so there is a component, however unless someone else uses it and can give you some info, I’m not sure what you can do.
Since you are running 
Since there is no component for scsgate and you would need to install scsgate with sudo pip install scsgate, which you can’t do in