Hi all
I had recently had the SkyConnect connected to a HASS instance as a Thread Border Router connected as well.
The instance had unfortunately been removed and decided to migrate to a dedicated RPi 4 to run everything on.
The SkyConnect integration shows up but when I click on “Configure” I am presented with an error “Failed to probe the usb device” (attached)
Is there anything I can do to fix it, I’m guessing it needs to be reset in some way.
Did you solve your problem?
Actually had solved it today
The firmware was actually flashed as ZHA Multiprotocol - so I needed to install the Silicon Labs Multiprotocol addon first and then add the ZHA Multiprotocol integration, this allowed me to setup the Thread Border Router integration too.
Might be off topic, but I found this which might be my issue.
I can’t test this at the moment though.
I’m seeing this error for my UNRAID VM of HA, I’ve found no documentation other than that its supposed to be plug-and-play with Home assistant.
I see mention of some add-on. So If I install that add on everything works?
Make sure you pass through the usb port to your VM
