Adding an Aqara Smart Temperature Humidity/Sensor

yan · January 1, 2019, 9:05pm

Hi,

I use a Conbee Stick (Link)

For getting it integrated i use the Deconz addon

marthoc/hassio-addons/blob/master/deconz/RASPBEE-SETUP.md

## Configuring ResinOS / HassOS for RaspBee

If your RaspBee module is not detected and assigned a device name (/dev/ttyAMA0 by default, though possibly /dev/ttyS0), edit the config.txt file in the root of your SD card as follows, depending on the Raspberry Pi model you are using, then reboot the Pi.

### Raspberry Pi 3B and lower

Add the following lines to the end of config.txt:
```
enable_uart=1
dtoverlay=pi3-disable-bt

```
(Be sure to add a blank line at the end of the file, some users have reported that the parameter is not recognized without the blank line.)

### Raspberry Pi 3B+

Add the following lines to the end of config.txt:
```
enable_uart=1
dtoverlay=pi3-miniuart-bt

This file has been truncated. show original

It works fine withe my xiaomi door/window sensors and my osram smart plugs. For my hue lights and sensors I use the Hue bridge.

It should work with Aqara Humidit Sensor, but mine hasn’t arrived yet.

For more informations see