💡 Sensor Light - Motion Sensor - Door Sensor - Sun Elevation - LUX Value - Scenes - Time - Light Control - Device Tracker - Night Lights

[Blacky]

@SoccerTX

In other words, I want it to go from 3% brightness in the early morning when lux is zero, and then are some crossover point (say 4pm) I’d like it to remain at about 14% brightness until it turns off by schedule at 11pm.

Have you looked at this blueprint Smart Light.

If you use time as the trigger say ON at 6am and off at 11pm 3% brightness. Then use night lights from 4pm till 11pm at 14% brightness. If you would lux here you can use a template binary sensor that looks at a lux sensor to see if it is below X and then use that as the state condition… is lux sensor below X then ON

Blacky