My module is labeled MS-104 on the box. Chip is labeled Model: WA2, P/N 2.22.29.00001.
Main PCB is labeled Dz1WF1MdM V1.1 and the daughter board that holds the chip and relay is labeled Dz1WF1MdS V1.1. The left side of the daughter board has the 2 terminal for switching the relay’s 5v coil, and what appears to be an unpoppulated R13 and D5 (likely to be a LED that tells you when the coil is energized.
Pinout is 5 pins that I can see with labels hidden by the PCB. I cannot see the other side.
I see both modules are physically compatibles, so if you have a TYWE2S with Tasmota the template must work. But is TYWE2S cheaper and easy to buy than ESP?
Hello,
I have recently buy two MS-104B (MoesHouse) from chinese BG store.
Opened to change WB2S with BK7231 chip with ESP12 I have see this is connected to main board with 8 pin. Looking schema of jump board I see also the pin used are different.
From one side I have on main board +3.3V | GND | PWM 0 | PWM 2 |
Other side starting side of +3.3 I have RX | PWM 1 | PWM 5 | PWM 4 |
With a tester I have see:
the Relay 1 is commanded thrue PWM 0 (also I have a brief low level on PWM 5)
the Relay 2 is commanded thrue PWM 2 (also here a brief low level on PWM 4).
In next days I will try substitution, but my question is anyone have found what doing other pin except power supply and 2 command of relay?
And as reported in document reported by @Miguel_Alvarez on his post #72 there are module +RF: any info about this?
Has anyone replaced WB2S on sockets like this with power metering? As I understand it’s just a matter of correctly soldering PWM to PGIO and then mapping in tasmota for correct functionality?
Also a space seems to be quite tight, wondering if anyone managed to squeeze it in?
in the same situation with the same WB2S chip
the wb2s and the TYWE2S looks similar
was wondering how to connect all the GPIO’s and get the power monitor working
I have the exact same device with the WB2S chip.
I also turn out to have an esp 12-F, esp M3 and esp M2.
Based on the pins that have to be connected I think that both esp M2 and esp 12-F should do the job and I will try to do it with them.
What I was wondering was what is your configuration that you use in Tasmota to show the power monitoring?
Could you share it here?